Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Everett?
Garage door work in Everett typically runs $150 to $600 for a repair, while a new door installation lands in the $700 to $2,200 range. A single spring runs $180 to $340, and most homeowners we connect with in Everett spend closer to the lower half of these ranges because a single broken part is usually the whole problem. Every figure here is an estimated typical range for the Everett market. The written estimate sets the final price.
We’re a garage door specialist, not a general handyman outfit. Our technicians have up to 10 years of experience, and every service call is 100% garage doors, so the person looking at your door has seen that brand and that failure before. Call (844) 662-2561 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Typical Everett repair range: $150 to $600, depending on the part that failed.
- A single torsion or extension spring: $180 to $340. A matched pair costs about twice that, since pairs are usually replaced together.
- Opener repair lands at $120 to $320; a new opener with installation runs $250 to $550.
- New door installation: $700 to $2,200, driven mostly by door size, material and insulation.
- Estimates are free, and the written estimate is what you pay.
Garage Door Cost Breakdown (2026)
Here’s how the numbers shake out across the services we handle in Everett. These are typical estimated ranges for 2026. Your door, its brand and the condition of the surrounding hardware will move you within them.
| Service | Typical Estimated Range | What It Covers |
|---|---|---|
| Garage Door Repair (general) | $150 – $600 | Diagnosis plus the failed component, from hinges to bottom brackets |
| Spring Repair (one spring) | $180 – $340 | Single torsion or extension spring replacement |
| Spring Repair (matched pair) | About twice the single range | Both springs replaced together, which is standard practice |
| Cable Repair | $130 – $250 | Lift cable replacement per side, including the drum check |
| Opener Repair | $120 – $320 | Motor, logic board, gear, sensor or remote issues |
| Opener Installation | $250 – $550 | New opener supplied and installed, incl. smart/Wi-Fi models |
| Panel Replacement | $250 – $500 | Dented or damaged section swapped for a matching panel |
| Track Realignment | $120 – $240 | Bent or knocked-out track straightened or replaced |
| Roller Replacement | $110 – $220 | Full roller set, nylon or steel |
| New Door Installation | $700 – $2,200 | Door, hardware, and haul-away of the old door |
What pushes a job toward the top of a range? Several things. A door with two springs costs more than one with a single spring, because both usually get replaced at once. A brand with harder-to-source hardware adds time. So does rusted or seized hardware that fights every adjustment. A door that’s been out of alignment for a while often needs a track and roller set alongside the original repair, and those add up. On installation, a double-car door costs more than a single, insulated doors cost more than uninsulated, and a door with windows or a carriage-house style costs more than a plain raised-panel. The estimate you get should itemize which of these applies, so you can see exactly where the money goes.
What Affects Garage Door Pricing in Everett
Everett is an older, dense city, and that shapes what we find on doors here more than anything else. Roughly a third of the housing stock is multi-family, and a lot of the two- and three-deckers around Glendale Park and the Woodlawn neighborhood have garages that were built decades ago and patched together since. Here’s what moves the number:
- Age of the door and hardware. A door from the 1970s or 1980s often has extension springs rather than torsion, and the hardware around them has usually been adjusted many times. Converting to a torsion setup or replacing worn brackets changes the scope and the price.
- Brand and part availability. We work on eight major brands: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor. Common parts for these are in stock, which keeps the job a single visit. A door outside that list may need a special order, and that adds time and cost.
- Freezing winters and road salt. Everett gets hard freezes and a lot of road brine tracked onto garage floors. That corrodes steel rollers, hinges and bottom brackets faster than in milder climates. Rusted hardware is one of the most common reasons a routine repair turns into a roller and hinge replacement too.
- Single vs. double door. A double-car door uses heavier springs and more panels, so spring, cable and installation costs all run higher than on a single.
- Opener type. A legacy chain-drive opener is straightforward to repair. A modern Wi-Fi or smartphone-connected LiftMaster or Genie unit needs someone who knows that platform’s logic board and sensor setup. We handle both, so the price doesn’t jump just because the opener is smart.
- Weather and wind exposure. Doors on the windward side of a building take more strain on the tracks and panels. A door that’s been pushed out of alignment needs realignment work on top of whatever else failed.
How to Save on Garage Door
The cheapest garage door repair is the one you catch early. A door that starts squeaking or running rough is telling you a roller or hinge is failing, and a $110 to $220 roller replacement beats a $600 repair once the hardware has chewed up the track. Here’s what actually saves money in Everett:
- Fix small noises before they become failures. Squeaks, grinding and slow starts are early warnings. Address them and you stay near the bottom of the repair range.
- Replace springs in pairs. If one spring breaks, the other is the same age and under the same load. Replacing both now costs about twice a single spring but avoids paying for a second service call soon after.
- Match the part to the brand. A generic fix on a Clopay or Amarr door can void the door’s balance and wear the opener out early. Getting the right part the first time, from a company that stocks common components, means one visit instead of two.
- Get the free estimate in writing. An itemized estimate shows you what’s a repair and what’s an upsell. If a company can’t explain why a panel or an opener needs replacing, ask.
- Keep the tracks clean and the hardware lubricated. A few minutes with a rag and the right lubricant a couple times a year keeps rollers and hinges from seizing in the cold.
None of this is exotic. It’s the difference between a $150 hinge-and-roller job and a $600 repair after a track has been bent. For a free estimate on your door, call (844) 662-2561. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Repair or Replace: Which Makes Sense in Everett?
Repair usually wins when one or two components have failed and the door itself is sound. Replace when the door is old, rusted through, or has been patched so many times that the next failure is already waiting. As a rough guide: if the repair estimate is more than about half the cost of a new door, and the door is already showing wear across several areas, replacement is often the better value. A $180 to $340 spring repair on a door in otherwise good shape is a clear repair. A $500 panel replacement plus a $250 track realignment plus new rollers on a 30-year-old steel door starts to approach the $700 to $2,200 install range, and at that point a new door from Clopay, Amarr, Wayne Dalton or Raynor buys you a fresh warranty and a decade of trouble-free operation. Ask for both numbers and decide with them in front of you.
Why Springs and Cables Need a Specialist
A torsion spring holds enough stored energy to cause serious injury if it releases while someone is working on it, and lift cables are under the same load. This is not a job for guesswork or for a general handyman who happens to own a wrench. We treat spring and cable repair as a core service rather than something to refer out, and our technicians have up to 10 years of experience working on these systems specifically. When we’re on a door, the work is done with the proper winding bars and the right load calculations for the door’s weight. That’s also why a spring repair is priced per spring and quoted clearly: a matched pair is usually replaced together, so a pair costs about twice the single-spring range. If a spring has failed, don’t run the opener. Call us at (844) 662-2561 and we’ll get a technician out. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What Happens When You Call
You describe the door and what it’s doing. We ask about the brand and the symptom, because that narrows the likely cause before anyone leaves. A technician arrives, inspects the full system (springs, cables, tracks, rollers, hinges, opener), and gives you a written estimate before any work starts. If it’s a part we stock, most repairs finish on that first visit. If it needs a special order, we tell you the timeline up front. Either way, the estimate is free and the written price is what you pay. You can reach us at (844) 662-2561. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
FAQs – Garage Door Cost
How much does garage door repair cost in Everett?
Garage door repair in Everett typically runs $150 to $600, depending on the part that failed. A single broken spring is $180 to $340, a cable repair is $130 to $250, and a roller replacement is $110 to $220. Call (844) 662-2561 for an exact quote. Estimates are free.
How much does a new garage door cost in Everett?
New door installation in Everett typically runs $700 to $2,200. Single-car and uninsulated doors sit near the low end; double-car, insulated, or windowed doors land near the top. The written estimate sets the final price. Call (844) 662-2561 for a free estimate on your door.
Is it cheaper to repair or replace a garage door?
Repair is usually cheaper when only one or two parts have failed and the door is otherwise sound. If the repair estimate climbs past about half the price of a new door, replacement is often the better value. A $180 to $340 spring repair is a clear repair; a multi-part fix approaching $700 to $2,200 tips toward replacement. Get both numbers in writing. Call (844) 662-2561.
Why does a spring repair cost so much?
A single spring repair typically costs $180 to $340 because the work is high-risk: springs store extreme tension and require specialist handling, proper winding bars and correct load calculations. A matched pair costs about twice that, since pairs are usually replaced together. Call (844) 662-2561 for a free estimate.
Can you come today?
Same-day service is available, and dispatch runs from 7am to 7pm, Sunday through Friday. We answer the phone 24/7, and a call outside dispatch hours is booked into the next opening. Call (844) 662-2561 to check availability for your Everett address.
Get a Free Estimate on Your Everett Garage Door
Whether it’s a broken spring, a smart opener that won’t connect, a dented panel from a backed-in car, or a full new door, we can tell you what it costs before any work begins. We’re a garage door specialist working on the eight major brands homeowners actually own: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor. Our technicians have up to 10 years of experience, and common parts are in stock so the fix happens on the first visit whenever possible. For the full range of what we do, see garage door repair South Boston. Call (844) 662-2561 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Everett market as of 2026. Garage Door Repair South Boston offers free estimates – call (844) 662-2561.
What Our Customers Say
"They were the only ones willing to just tell me the price. Everyone else wanted to "come take a look" first, which in my experience means come apply pressure in person."
- Tim Novak"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Dana Ziegler"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Brooke Sullivan